I’m from Germany and going to build an HK416N (VFC HK416 basis) for my norwegian-kit.
So excuse me for writing in English.
If I posted in the wrong board-categorie, please excuse me, I wasn't sure.
It would be great if you can help me with this:
I need the exact dimensions of the barrel, for producing an outerbarrel-extension.
This dimensions and the outer-diameter of the barrel.
(Z is the distance from the gasblock to the small groove/notch which goes around the barrel)
I also need good hires pictures of all markings to create a data to laser engrave the markings.
Especially from these:
Good pictures from the gasblock (with and without RAS) would also be great

Thank you very much!
Greets
Daniel